DWC_Authdata Spoofer; DBZ BT3
#1
DBZ BT3 DWC_Authdata Spoofer

Also known as User ID Spoofer. This code allows a user to have a fully spoofed DWC_Authdata/User ID. Do not exceed the value of 000009184E729FFF (9999999999999 in decimal). Legit authdatas cannot exceed that limit. If you exceed that limit, a server mod/admin will instantly know you are using spoofing codes. Thus, if you follow this rule, your XXXX value will always be 0000.

Another thing to know, is that you this code on an existing Wifi Profile, you will get EC 60000. You will need to reset/initialize your Wifi Profile. When you make a Wifi Profile and get a new FC while using this code, you will need this code every time (with the same authdata value) to get on Wifi again on the same profile, or you will get EC 60000.

NTSC-U
C22D6190 00000004
3CE0WWWW 60E7XXXX
90E601B0 3CE0YYYY
60E7ZZZZ 90E601B4
80E601B0 00000000

WWWWXXXXYYYYZZZZ = Your desired DWC_Authdata in HEX



Source:
lis r7, 0xWWWW #Load the WWWW value into the upper 16 bits of Register 7, clear the lower 16 bits
ori r7, r7, 0xXXXX #Load the XXXX value into the lower 16 bits of Register 7
stw r7, 0x01B0 (r6) #Store the word (WWWWXXXX) of Register 7 at the address of Register 6 plus offset of 0x01B0
lis r7, 0xYYYY #Load the YYYY value into the upper 16 bits of Register 7, clear the lower 16 bits
ori r7, r7, 0xZZZZ #Load the ZZZZ value into the lower 16 bits of Register 7
stw r7, 0x01B4 (r6) #Store the word (YYYYZZZZ) of Register 7 at the address of Register 6 plus offset of 0x01B4
lwz r7, 0x01B0 (r6) #Load the word at address of Register 6 plus offset 0x01B0 into Register 7; Default Instruction



Code creator: zak
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)